|
Post by sifuconman on Oct 9, 2018 19:05:18 GMT 8
Hi Kerui G18 console is supposed to have an anti tamper feature i.e. the alarm will be triggered if some one try to tamper with the alarm console such as removing it from the wall. Does anyone know how to set it ? Thanks ! EDIT : I had tried setting the anti temper alarm to ON but still did not work ! I believe either the anti tamper switch is broken or it is physically absent ! Any one manged to get this anti tamper switch working ? EDIT : I managed to get a photo of the Kerui G18 internal layout and apparently there is no anti tamper switch built in ! Attachments:
|
|
mb93
New Member
Posts: 8
|
Post by mb93 on Oct 13, 2018 22:00:59 GMT 8
I understood how the anti-tamp works. In fact, there is no motion detector, it's much simpler:
The G18 is supposed to be fix on the wall support (by the 2 rear holes).
In the second hole of G18, there is a metal contact (which is the anti-tamp detector) in touch with the wall support.
When the G18 is removed from the support, it pushes this metal contact and the anti-stamp is triggered. Without support, no anti-tamping alarm ! You can also test it by pressing the metal contact with a clip or something thin. Best regards
|
|
|
Post by sifuconman on Oct 14, 2018 19:09:59 GMT 8
mb93
Thanks for the info. You are right ! I tested by pushing the metal contact and the alarm went off. However, it didn't work when I inserted and removed the support. I guess there is something wrong with the support or alignment of the anti tamper switch.
|
|