faruk
New Member
Posts: 1
|
Post by faruk on Aug 6, 2018 22:04:26 GMT 8
Merhaba ;
Ben sadece uyarı sırasında siren çalmak istiyorum videoda uyarı sesleri iptal etmek
istiyorum
Daireler çok rahatsız edici
bana yardımcı olabilir
|
|
|
|
Post by Russel on Aug 27, 2018 11:28:28 GMT 8
Türk: Uzaktan kumanda ayarları altında açma / kapama devreye girdiğinde ve devre dışı bırakıldığında, uygulamadaki W1'i dış siren sesinden çifte bip sesiyle biliyorum. (Google çeviri, gramer için özür dilerim)
English: I know on W1 on the app the double beep sound from the outside siren when arming / disarming is turned on and off under the remote control settings. (I used google translate, sorry for grammar).
|
|
|
|
Post by Cătălin on Sept 2, 2018 14:50:01 GMT 8
hello! i have the same issue with my w18. i would like to disable that siren sound when arming/disarming. is it possible! thanks in advance.
|
|
|
|
Post by Sanyesz on Sept 11, 2018 23:23:20 GMT 8
Solution!
|
|
|
|
Post by charltonfan1 on Apr 8, 2019 2:24:07 GMT 8
I have followed the video instructions for my W18 external solar siren but it doesn't work.
I don't know which Sound zone my solar alarm is set to as it was setup by the AliExpress seller.
I have changed the setting for zones 00-40 and 90-99 but still no luck.
My solar alarm is on my house wall operational. Does it need to be close by or in setup mode for this setting to be changed?
Thanks
|
|
|
|
Post by cougar81 on Aug 13, 2020 2:46:38 GMT 8
I have followed the video instructions for my W18 external solar siren but it doesn't work. I don't know which Sound zone my solar alarm is set to as it was setup by the AliExpress seller. I have changed the setting for zones 00-40 and 90-99 but still no luck. My solar alarm is on my house wall operational. Does it need to be close by or in setup mode for this setting to be changed? Thanks Although it has been a while since your question I just saw it and I answer it, in case it serves you or anyone else. The most important thing is to know what is the code or zone in which your sensors are registered, for this you must make it detect the alarm and start to sound, and looking at the screen you will see that it says something like '04 detected 'then your zone would be 04. Deactivate the alarm and on the menu screen press 3 -> settings, then 6 -> sound. In the section that comes out you put 04, or 3l zone code from the previous step, and press ok. On the next screen where you put on by pressing the menu key you change it to off. All you have to do is click ok to record and exit to the main menu. With this you get that it does not emit a beep when you arm or disarm it |
|
